Need thoughts on bending an aerial?

General Mobile CB antenna advice and troubleshooting
Post Reply
Irishman
New to the Scene
New to the Scene
Posts: 5
Joined: Wed Oct 07, 2020 2:27 pm

Hi all, Im new here so be gentle :D

So, I have a Mazda Bongo (picture below of one the same as mine for those that have never heard of them) and fancy a CB and want the best range I can get, so likely a 1.5m plus aerial.

However Im wondering about bending the aerial so that the tip is "captured" and therefore it's basically an arc?

My problem is, on the picture below you'll notice the elevating roof, that's fibreglass so rules out a mag mount anyway, so im wondering about either a gutter mount on the front driver side then captured at the rear of the gutter or even a bullbar mount which could then be captured up on the driver side gutter.

I guess my main worry is if this would in fact reduce the range?

Any thoughts appreciated for a newbie. :? :?

Image
User avatar
Hair Bear
Chatter Box
Chatter Box
Posts: 126
Joined: Tue Jun 02, 2020 6:04 pm

Hi, I'm not sure what the legality of long bull bar mounts is in the UK, and as soon as you clip it down it will earth to the body and be almost useless.
From memory the Mazda Bongo / Ford Friendee do have gutters so knowing your grp lifting roof arrangement I would suggest 'co-phased twins'.
You will require 2 gutter mounts with matching coax lengths, 2 antennas (Possibly Springer or Half Breed types), and a coax 'T' joint.
Set one mount above the o/s B post, run the coax, fit the antenna, connect to the rig and swr. Do the same for the n/s, then fit the T into the rig and attach the coax to each side. Don't change the cable lengths, they must match.
You will find the n/s antenna will take a battering from hedges and trees, and when parked with the roof up they will tap against the roof in the wind.
This is a set up I've used for many years on various small to medium sized vans and it does work. It can be enhanced by using RG59 coax but that's just getting technical. There will be those who say the antennas need to be at least 8' apart for a co-phase system to operate properly and maybe it works better at that separation but it's an arrangement that's never given me any real problems.
Good luck.
One person in ten understands binary. The other one doesn't. :wink:
Post Reply